如题，谢谢

十分感谢，前面那个带英文的是正确的，后面一位朋友多敲了一两个字，哈。。。。总之还是很感谢

Checking shutter count on E-p1, E-P2, E-PL1 & E-PL2

By following these steps you can check your shutter count as well as a few other things. Follow these steps:

1. While holding the "Menu" button, press Power button to switch on   
     按住Menu键的同时按电源键

2. Press "Menu" and go to "Monitor brightness adjustment" screen   
    按Menu进入菜单，进入屏幕亮度调整

3. Press "Info" and "OK" button at same time, you will see the screen showing "Olympus"  
    同时按住Info和OK键，这时你应该可以看到屏幕上显示Olympus...

4. Press the following buttons in the sequence: Up, Down, Left, Right and then press the Shutter, followed by Up (dial button in my E-P2)
    按顺序按下： 上，下，左，右，快门，上，你就能进入工程菜单了

5. Engineering mode page is seen. Press dial button to Page 1, 2, 3, and "D".  
    通过上下左右键进入Page1, 2, ,3, D

6. Shutter count is on "Page 2" under "R".  
    其中， Page 2的R 显示的就是快门数。

The other lines on the screen mean:

R: shutter release count 快门数
S: flash use count  闪光数
C: CMOS cleaning mode (with mirror lock-up - in E-410 series)  
U: number of ultrasonic dedusting, ~ number of power switch on  自动除尘数（相当于电源开关次数）
V: number of use of LiveView  使用Liveview的次数
B: number of shot using In-Body Stablization  使用防抖的次数

Please be careful when doing this. Although it's probably perfectly safe to do this i hold no responsibility if you mess up your Pen.

按这menu开机，进入屏幕亮度调节那里，然后按ok，在按上下左右快门上右，r后面的数字就是快门，b是防抖次数，s是闪光次数，u是除尘次数。